Resetting Aterm WR8750N to factory default state

Tadashi Shigeoka ·  Fri, March 21, 2014

A memo of the procedure to reset Aterm WR8750N to factory default state.

1. Confirm that the Aterm power is on.
  1. Hold down the main unit’s RESET switch until the POWER lamp blinks red. Use a thin rod-like object (such as a toothpick made of non-conductive material) to press the RESET switch. (For WR8165N, hold down the reset button on the bottom of the main unit until the POWER lamp blinks red.)

  2. When the POWER lamp starts blinking red, release the RESET switch.

  3. Turn off the Aterm power. Wait about 10 seconds and turn the power on again. After turning on the power, the initialization process takes about 1 minute.

When continuing with configuration, please wait at least 1 minute before proceeding.


Reference Information

初期化方法が知りたい

That’s all from the Gemba.